As we all know , before manufacturing led lights, it’s very important to do SMT factory planning , especially for the newly-built SMT factory, because itself has no experience in SMT factory design layout, about SMT workshop design , there maybe some attention points lost.After start production, if discovered the existence of the problem point, maybe causing unnecessary losses.So when doing the design of the SMT factory layout, should prepare for what in advance? So we must know SMT clean mounting workshop production requirements.
1.Workshop bearing capacity, vibration, noise requirements:
Factory ground bearing capacity should be greater than 8 kn/m2. Vibration should be controlled in less than 70 db, the maximum value of no more than 80db. The noise should be controlled within 70 dba.
2.Power supply:
General requirements of single-phase AC220 (220 + / – 10%, 0/60 hz), three-phase AC 380 (380 + / – 10%, 50/60 hz), more than double the power consumption of power supply of power than.
3.Air:
According to the requirement of the equipment configuration of air pressure, can use plant air, and also be configured individually oil-free compressed air machine, general pressure is greater than 7 kg/cm2.
For clean, dry cleaning the air, so the need for compressed air to oil, dust and water treatment.Made from stainless steel or pressure plastic air duct.
4.Exhaust:
Reflow soldering and wave soldering equipment need exhaust fan.For hot blast stove, exhaust pipe of the minimum flow rate value is 500 cubic feet per minute (14.15 m3 / min).
5. Lighting:
In the ideal of the plant Illumination is 800 ~ 1200 lux, at least not less than 300 lux, when low intensity of illumination, in the inspection, repair, measurement work areas should install local lighting.
6.The work environment:
Factory to keep clean, no dust, no corrosivegas.Production workshop should have cleanliness control, control the cleanliness: the class of 500000. Production workshop environment temperature to 23 + / – 3 ℃ is the best, average of 17 ~ 28℃,relative humidity is 45% ~ 45% RH.
